Optical Block Position Adjustment - Panasonic PT- 65WX51E Service Manual

5. Wire the anode lead wire.
Optical Bracket (Front)
RED CRT GREEN CRT
Figure 17. Wire Guide.
6. Install yoke with other CRT neck assemblies on
CRT neck in the same order and position as
removed from the defective CRT.
The optical block mounting has holes to allow for the
different size projection screens. These mounts will
adjust to 61 inch & 51 inch projection screens.
Service Manual
7. Press yoke against bell of CRT and tighten the
8. Assemble CRT focus lens assembly to new CRT
BLUE CRT
Note: Please assemble with screws in the order

Optical Block Position Adjustment

Figure 19. Optical Block Position.
If the optical block is removed for service or is
replaced, it is important that the correct mounting holes
are used.
- 14 -
clamp just snug enough so it will not easily shift.
with (4) screws. Make sure focus lens adjustment
nut is in the same location as on other CRT focus
lens.
1
3
Figure 18. CRT Screw Tightening Order.
shown and tighten with the same torque.
51/61
46
51/61
46
51/61
46
51/61
46 51/61
46
51/61
46
4
2