Intermec 700 Series 700 Installation Instructions Manual page 32

SECTION 3
2. Cut the red wire in the battery power cable midway
3. Strip 1/4-inch of insulation from the red wire that ex-
4. Slide the longer portion of the in-line fuse holder boot
5. Slip a fuse clip onto this wire and crimp the clip onto
6. Slip the remaining fuse clip onto one end of the 6 inch
7. Slide this wire into the other half of the fuse holder
8. Go to Terminating the Wire Ends.
between its end and the cable jacket. Save the 6--7
inch length of red wire.
tends from the vehicle power cable; also strip 1/4-inch
of insulation from both ends of the 6 inch length of red
wire saved in step 2.
(yellow rubber) over the red wire that extends from
the power cable.
the wire.
wire saved from step 2 and crimp securely.
boot. Insert the fuse into the fuse clips and snap the
halves of the fuse holder boot together.
700 Series Dock Installation Instructions
Vehicle Dock Installation
3-9