Clearing A Clog - Bissell CLEANVIEW SWIVEL REWIND PET REACH Manual

Replacing the Brush Roll and Belt
For additional support videos and information, visit support.BISSELL.com.
1. Unplug vacuum, turn over
and unscrew six (6) Phillips-
head screws to remove the
bottom cover. Lift brush
straight out.

Clearing a Clog

We have additional tips for maintaining your machine at support.BISSELL.com.
1. Remove the hose from the
back of the vacuum by twisting
it counter-clockwise. Remove
any debris.
WARNING
before performing maintenance or troubleshooting checks.
2. Clean debris from brush
roll. Inspect by placing on its
end and spinning. The brush
roll should spin freely, multiple
times by one flick. If it doesn't,
replace brush roll. Check belt
for wear or cuts and replace if
necessary.
2. Check the foot hose on the
back. If necessary, remove the
screw from the foot hose and
check for clogs.
To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet
3. Replace the brush roll and
belt by looping the belt over
the motor shaft and the brush
roll. Line up the endcaps and
pull the brush forward into
place. This will stretch the belt.
Return bottom cover back on
and replace the screws.
3. Check the air passageway
on the bottom of your vacuum.
Remove the bottom cover and
the brush. Remove any debris.
BISSELL.com 7