Clearing A Clog - Bissell Powerlifter Swivel Pet 2260 Series User Manual

Replacing the Brush & Belt
WARNING
To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical
outlet before performing maintenance or troubleshooting checks.
1
Unplug vacuum, turn over and unscrew
six (6) Philips-head screws to remove
the bottom cover. Lift brush straight out.
3
Replace the Brush Roll and Belt by looping the Belt over the motor shaft and the
Brush Roll. Line up the end caps and pull the brush forward into place. This will
stretch the belt. Return bottom cover back on and replace the screws.

Clearing a Clog

1
Remove the Stretch
Hose from the back
of the vacuum by
twisting it to the left.
Remove any debris
that may have gotten
clogged.
Belt
Endcap
2
Check the Foot hose on
the back of your vacuum
down towards the bottom.
If necessary, remove the
screw from the Foot hose
and check for clogs.
2
Clean debris from Brush Roll. Inspect by
placing on its end and spin. The Brush
Roll should spin freely, multiple times by
one flick. If it doesn't, replace Brush Roll.
Check Belt for wear or cuts and replace
if necessary.
3
Check the air passageway on
the bottom of your vacuum.
Remove the bottom cover and
the brush. Remove any debris.
www.BISSELL.com
9