Lincoln Electric POWERTEC i450C ADVANCED Operator's Manual page 15

Hide thumbs Also See for POWERTEC i450C ADVANCED:
Table of Contents

Advertisement

Gas Connection
WARNING
CYLINDER may explode if damaged.
Always fix the gas cylinder securely in an
upright position, against a cylinder wall
rack or purpose-made cylinder cart.
Keep cylinder away from areas where it
may be damaged, heated or electrical
circuits to prevent possible explosion or
fire.
Keep cylinder away from welding or other
live electrical circuits.
Never lift welder with cylinder attached.
Never allow welding electrode to touch
cylinder.
Build up of shielding gas may harm health
or kill. Use in a well-ventilated area to
avoid gas accumulation.
Close the gas cylinder valves thoroughly
when not in use to avoid leaks.
WARNING
Welding machine supports all suitable shielding gases at
a maximum pressure of 5,0 bar.
WARNING
Before use, make sure that the gas cylinder contains gas
suitable for the intended purpose.
Turn off input power at the welding power source.
Install a proper gas flow regulator to the gas cylinder.
Connect the gas hose to the regulator using the hose
clamp.
The other end of gas hose connect to the gas
connector on the power source rear panel.
Turn on input power at the welding power source.
Open the gas cylinder valve.
Adjust the shielding gas flow of the gas regulator.
Check gas flow with Gas Purge Switch [23].
WARNING
To weld GMAW process with CO
heater should be used.
English
shielding gas, CO
gas
2
2
Transport & Lifting
Falling equipment can cause injury and
damage to unit.
During transportation and lifting with a crane, adhere to
the following rules:
The device contains elements adapted for transport.
For lifting a suitable lifting equipment capacity.
For lifting and transport use minimum four belts.
Lift and transport only power source without gas
cylinder, cooler, or/and any other accessories.
13
WARNING
Figure 7
English

Advertisement

Table of Contents
loading

Table of Contents