MobileHelp Mobile Double System Quick Start Manual page 2

QUICK SETUP
Your System is "ACTIVE" and READY TO USE
Mobile Double System
Includes 2 mobile devices, 2 neck
pendants/wrist buttons, 2 cradle
chargers and 2 mobile cases
Plug both power cords into
electrical outlets
The electrical outlets should NOT be
controlled by a light switch
Place both Mobile Devices on
The yellow light on the front of the Cradle
Charger will illuminate.
The Mobile Device will turn on within 10 seconds
and then it will take approximately 60 seconds
for the Mobile Device to register with the
network.
he red battery light will illuminate, indicating
that the device still needs charging. When the
device is fully charged, the red light will turn off.
It will take up to 3 hours for the device to be
fully charged.
Next, be sure to test your system... see Testing page.
1 1
Quick Start Guide CBS 4 MD 3 MHP8003-455A_mech.indd 2 Quick Start Guide CBS 4 MD 4 MHP-06776A_mech.indd 2
Yellow
ON/OFF
Light
Switch
SRDR-00007 Rev 2
MobileHelp Customer Support 1-877-827-6207 Quick Start Guide
TESTING
Mobile Double System
1
Press the emergency button
2
or pendant
Both mobile devices will announce, "Test
Call sent to Emergency Response Center"
Always have your Mobile Devices nearby when testing your system. It is possible that a
Mobile Device will go to a live operator. If the operator speaks to you, please advise them
that you are testing your system. If you do not explain to the operator that you are okay and
that you are testing, EMS may be contacted.
3 If the test was successful...
Both mobile devices will announce,"Thank
you for testing your device"
If the test was unsuccessful...
4
Mobile devices will announce, "User
auto-test failed, please contact Customer
Support"
PLEASE REFER TO THE CUSTOMER SERVICE NUMBER ON
THE INSERT THAT CAME WITH THIS GUIDE FOR ANY
QUESTIONS OR CONCERNS.
If you have not set up your system...
MobileHelp Quick Start Guide Quick Start Guide
see Setup page first.
SRDR-00007 Rev 2
2 2
4/2/2019 11:29:49 AM 4/2/2019 11:29:49 AM