Remote Restarting The Device - Proconx MODG-100 User Manual

Once you click Save the new settings are stored and applied instantly. A confirmation
message is shown.
It is of great importance to ensure that there is not two devices with the same
Modbus address. In such a case, an abnormal behavior of the whole serial bus can
occur, the master being then in the impossibility to communicate with all present
slaves on the bus.
The protocol (RTU or ASCII) and serial port parameters must be the same for all
devices on a Modbus serial line.

Remote restarting the device

You can perform a remote restart of the device from the web interface. A remote restart
is similar to power cycling the device. Possibly connected clients are disconnected and
communication is interrupted until the device has rebooted.
To perform a remote restart, click on the Configuration sub-menu and then click on
the Restart menu entry. This will open the device restart page as shown below:
Figure 5.9: Restart device page
Click on the Restart button to perform a restart of the device. The restart is confirmed
with the following notification:
Figure 5.10: Restart confirmation page
Please allow a few seconds before continuing working with the device as it has to fully
start-up first, before being able to respond to further web browser requests.
UMMODG100-2201
Web browser based management
23