Connecting Ethernet; Ethernet Connector Pinout - Proconx MODG-100 User Manual

• The shield must not be connected to the GND pin.
To connect the MODG-100 to a PC (Personal Computer) or any other device with
data terminal equipment (DTE) pinout you need a null-modem or cross-over cable.

Connecting Ethernet

The following table describes the 10BASE-T Ethernet RJ-45 connector pinout:
Pin
1
1
2
3
4
5
6
7
8
Table 3.4: Ethernet connector pinout
• We recommend to use Category 5 UTP network cable.
• Maximum cable length is 100 m (3000 ft).
UMMODG100-2201
Signal Function
TX+ Non-inverting transmit signal
TX- Inverting transmit signal
RX+ Non-inverting receive signal
Internal termination network
Internal termination network
RX- Inverting receive signal
Internal termination network
Internal termination network
Installation
9