Ranger Products RX3040 Quick Start Setup Manual

Hide thumbs Also See for RX3040:

Download this manual

REFER TO THE COMPLETE SAFETY, INSTALLATION AND OPERATION MANUAL IF YOU ARE UNSURE OF ANY

TIRE MOUNTING OR DEMOUNTING PROCEDURES OR HAVE NOT USED THIS STYLE OF TIRE CHANGER.

IMPORTANT! FOLLOW THIS SET UP GUIDE PRIOR

TO USING THE MACHINE OR DAMAGE TO THE

TIRE CHANGER OR RIM & TIRE MAY OCCUR!

1. The Centering Cone must make contact with the Hub

Hole Edge.

2. You MUST use the Turntable Spacer when the Hub

Hole of the Rim requires use of either of the Large Cen-

tering Cones.

3. Use of the Large Centering Cone without the Spacer

will prevent proper wheel mounting.

QUICK START SETUP GUIDE- Demounting

Setting the Bead Breaker Roller

and "Target Lock" Distance.

1. Set the distance from the Rim edge to the Bead

Breaker Roller to 1/8'.

2. Once this distance is set. DO NOT move the

Turntable. When you press the "Target Lock" Button for

the Bead Hook / Tab Arm, the Hook/Tab Arm will extend

and stop the same distance from the Rim that was set

with the Bead Breaker Roller.

3. ALWAYS liberally lube both Upper and Lower Beads,

then Hook Upper Bead as Shown.

Need help?

Do you have a question about the RX3040 and is the answer not in the manual?

Page 1 QUICK START SETUP GUIDE- Demounting REFER TO THE COMPLETE SAFETY, INSTALLATION AND OPERATION MANUAL IF YOU ARE UNSURE OF ANY TIRE MOUNTING OR DEMOUNTING PROCEDURES OR HAVE NOT USED THIS STYLE OF TIRE CHANGER. IMPORTANT! FOLLOW THIS SET UP GUIDE PRIOR TO USING THE MACHINE OR DAMAGE TO THE TIRE CHANGER OR RIM &...
Page 2 QUICK START SETUP GUIDE - Demounting Both the Upper and Lower Bead Breaker Rollers can 3. Locking the Lower Bead Breaker Roller will prevent articulate while breaking the tire bead by applying pres- the Roller from articulating and hitting /damaging the Rim sure closer to the Rim Edge.
Page 3 QUICK START SETUP GUIDE- Mounting REFER TO THE COMPLETE SAFETY, INSTALLATION AND OPERATION MANUAL IF YOU ARE UNSURE OF ANY TIRE MOUNTING OR DEMOUNTING PROCEDURES OR HAVE NOT USED THIS STYLE OF TIRE CHANGER. UPPER BEAD 1. ALWAYS liberally lube both Upper and Lower Beads, during mounting procedures, then position the Tool Head with the Tab Side down.
Page 4 QUICK START SETUP GUIDE- Mounting During operation of the RX3040 you will likely damage some of the components listed below. We supply spares with your Tire Changer, but you will always want to have some on hand and when training new operators.