On A Wall Plate - Radio Shack ET-294 Owner's Manual

43-633.fm Page 7 Friday, August 13, 1999 10:34 AM

On a Wall Plate

1. Plug one end of the supplied short
modular cord into the jack on the
bottom of the base, then route the
modular cord downward through the
groove on the bottom of the base.
2. Insert the supplied power adapter's
barrel plug into the jack on the back
of the base, then route the adapter's
cord through the strain-relief slot
and down through the groove on the
bottom right of the base.
3. Plug the short modular cord's other
end into the 2-line wall plate jack.
Then align the base's keyhole slots
with the wall plate studs and slide
the base downward to secure it.
4. Plug the adapter into a standard AC
outlet.
5. Slide the handset clip up and out of
its retaining slot, rotate it 180
slide the clip back into its slot.
Before you operate the ET-294, you
must connect the handset cord and ad-
just the line-status indicators. (See
"Connecting the Handset Cord" on
Page 9 and "Adjusting the Line-Status
Indicators" on Page 10).
o
, then
7