On A Desk; On A Wall Or Wall Plate - Radio Shack Caller Owner's Manual

1 " "&
0 # '5-
1. Insert the mounting bracket's four tabs into the slots on
the bottom of the base (as shown) then slide up and
snap the mounting bracket into place.
2. Plug one end of the supplied long modular cord into the
jack on the bottom of the base. Then route the
LINE
long modular cord through the strain left slot on the
mounting bracket.
3. Insert the supplied AC adapter's barrel plug into
jack on the bottom of the base. Then route the
200mA
adapter's cord through the right slot on the mounting
. . . .
bracket.
4. Plug the modular cord's other end into a modular phone
line jack, and plug the adapter into a standard AC
outlet.
1 " "9 " "9
0 # #.. 14 #..
To mount the phone directly on a wall, you
need two screws (not supplied) with heads that
fit the keyhole slots on the bottom of the phone.
15
Drill two holes 3 / inches (100 mm) apart.
16
Then thread a screw into each hole, letting the
3
heads extend about / inch (5 mm) from the
16
wall.
1. Place the flat end of the mounting bracket
face up and insert the bracket's four tabs
into the matching slots on the bottom of the
base. Then slide up and snap the bracket into place.
"2
.#6'
15
3
DC 9V
.
"%#76+10"
You must use a Class 2
!
power source that supplies
9V DC and delivers at least
200 mA. Its center tip must be set
to negative and its plug must fit the
phones's DC 9V 200mA jack. The
3
/
16
supplied adapter meets these
specifications. Using an adapter
that does not meet these
specifications could damage the
phone or the adapter.
/
16
• Always connect the AC adapter
to the phone before you
connect it to AC power. When
you finish, disconnect the
adapter from AC power before
you disconnect it from the
phone.
.
5