Keyestudio KS0436 Kit Manual page 236

Power supply voltage: VM=15V max, VCC=2.7-5.5V
Output current: Iout=1.2A(average) / 3.2A (peak)

Standby control to save power

CW/CCW/short brake/stop motor control modes

Built-in thermal shutdown circuit and low voltage detecting circuit

Filtering capacitors on both supply lines


Slide switch:
SWITCHES are components that control the open-ness or closed-ness
of an electric circuit.
Just like the momentary buttons used in earlier circuits, this type of
switch can only exist in one of two states: open or closed.
However, a switch is different in that it will stay in the position it was
last in until it is switched again.
Check out the circuit diagram and hookup table below to see how
Hookup Guide:
everything is connected.
236