Utopia Qube Installation Manual

Installation Guide
Qube Freestanding Washbasin Drawer Unit
Important Information
•
Read the instructions carefully.
•
Check the product for any signs of damage and remove any protective film.
•
It is recommended that a technically competent installer undertakes installation.
•
It is the installer's responsibility to carry out a thorough assessment of the wall type and the
weight of the cabinet and use appropriate fixings.
•
Care should be taken when drilling walls to avoid any hidden wires or pipes.
Installation
Remove the doors from the cabinet. To secure the unit
against the wall, screw the stretcher plates to the gable
panels of the cabinet as shown in the diagram. Ensure that
the screws used are suitable for the thickness of the cabinet.
Mark the position of the holes in the stretcher plates on the
wall with a pencil. Drill the positions marked with a suitable
drill bit.
Fasten the unit in position through the stretcher plates using
fixings suitable for the wall type.
If fitting a run of units, fix them together through the gable
panels. Where possible, try to hide the fixings behind shelves
or hinge plates.
Installing Handle Trim
•
Secure the fixing clips onto the gables using the
pre-drilled holes.
•
Insert the two T-bolts into the rear of the handle trim.
•
Place the handle trim in front of the fixing clips.
•
Slide the T-bolts to the end of the trim to lock it in position.
Drawer Adjustment
•
To raise or lower the drawer front, use a screwdriver to rotate
screw B.
•
To remove the drawer front, use a screwdriver to rotate screw C.
•
To adjust the drawer front left to right, use a screwdriver to rotate
screw D. Adjust the screws until the drawer front is equally spaced
on the cabinet.
Care & Maintenance
Furniture should be regularly dusted with a soft cotton or micro-fibre cloth. For more thorough
cleaning, occasionally wipe your furniture with a soft cloth dampened with a mild detergent
solution. Surfaces should be thoroughly dried with a lint free cloth to prevent watermarks. Under
no circumstances should solvent cleaning agents, bleach or abrasive cleaning agents or cloths be
used. Spills should be removed immediately using a clean cloth. All bathroom furniture will
deteriorate through prolonged periods of exposure to high levels of condensation so bathrooms
must be adequately ventilated using suitable extraction. Failure to ensure adequate ventilation
may invalidate your guarantee.