Utopia You Installation Manual

Installation Guide
You & i-Line Wall Mounted Washbasin Drawer Unit

Important Information

•
Read the instructions carefully.
•
Check the product for any signs of damage and remove any protective film.
•
It is the installer's responsibility to carry out a thorough assessment of wall type and the
weight of the cabinet and use appropriate fixings.
•
Care should be taken when drilling walls to avoid any hidden wires or pipes.
•
To prevent the cabinet falling down this product must be fixed using the wall attachment
device provided.
Installation
It may be necessary to snap the wall plate in half at the marked line
to create two wall brackets. Mark a horizontal line on the wall at the
required height X---X. Ensure that the wall brackets will fit inside the
width of the cabinet and are equally spaced to ensure even distribution
of weight. Secure the wall brackets to the wall using suitable fixings.
Hook the unit onto the wall brackets ensuring that the brackets are securely
Located.
To adjust the position of the cabinet on the wall, use the two screws in each
hanging bracket. The top screws will move the cabinet closer to or further
away from the wall. The lower screws will move the cabinet up and down.

Drawer Box Removal and Replacement

To remove the drawer box, pull the drawer out a short distance, lift
it upwards and back to release it from the runners.
To re-fit the drawer box, push the runners fully rearward into the
cabinet. Place the drawer box on the runners and push backwards.
An click will be heard as the drawer engages onto the runners.

Adjustment

To raise or lower the drawer front, remove the cover caps on both sides
of the drawer and use a screwdriver to rotate the screws as shown.
To adjust the drawer front left to right, remove the cover caps on both sides
of the drawer and use a screwdriver to rotate the screws as shown.
Adjust the screws until the drawer front is equally spaced on the cabinet.
Care & Maintenance
Furniture should be regularly dusted with a soft cotton or micro-fibre cloth.
For more thorough cleaning, occasionally wipe your furniture with a soft cloth
dampened with a mild detergent solution. Surfaces should be thoroughly
dried with a lint free cloth to prevent watermarks. Under no circumstances
should solvent cleaning agents, bleach or abrasive cleaning agents or cloths be
used. Spills should be removed immediately using a clean cloth. All bathroom
furniture will deteriorate through prolonged periods of exposure to high levels of
condensation so bathrooms must be adequately ventilated using suitable extraction.
Failure to ensure adequate ventilation may invalidate your guarantee.