Table of Contents
Advertisement
MEQ-2000
UTILITY MENU – Remote Control
The MEQ-2000 can be remotely controlled by RS-232 or MIDI. Any programmable
hardware of software MIDI controller may be used. A list of available commands is
included in Appendix I.
The Inter-M/Algorithmix proprietary remote software (DSP-2000R) provides excellent
visual control of the MEQ-2000's processing features, with fully bi-directional
communication, allowing you to access the MEQ-2000's parameters via a standard PC.
There are three active buttons in the REMOTE mode:
F1 – DEF
recalls a default setup
F5 – ENTER
confirms the most recently entered changes.
F6 – EXIT
returns to the UTILITY menu.
The available parameters in the REMOTE screen are:
REMOTE
selects RS-232 or MIDI control
BAUD RATE
selects the transmission rate for communication with the PC (RS-232 mode
only). It is important to select the same baud rate here as on your host
computer.
SOFFTHRU
directs the remote control data to the RS-232 THRU connector or to the
MIDI OUTPUT connector.
MIDI CH
selects the MIDI channel when MIDI control is in use.
Default values are: RS-232, 115.2kBits/sec, OFF, 0.
24/96 Multimode Equalizer
43
Advertisement
Table of Contents
