Table of Contents
Advertisement
MEQ-2000
There are four active buttons in CONFIG mode:
F1 – DEF
changes settings to factory default.
F4 – DIO
opens a submenu for setup of the digital output.
F5 – ENTER
confirms the most recently entered changes.
F6 – EXIT
returns to the UTILITY menu.
Parameter Window
The CONFIG parameters can be selected using the
the parameter wheel. The
After every change, ENTER appears at the F5 key, and must be pressed to confirm the
change.
Note that any configuration change causes the MEQ-2000 to reconfigure the module
chain. Therefore after pressing ENTER to confirm a change, the system will mute all
outputs for a few seconds while reconfiguring.
The available parameters are:
CONFIG
provides for selection of module configuration: MA-1, MA-2, RE-1, RE-2,
ME-1, ME-2.
INPUT
selects the signal source: ANALOG, DIG XLR, DIG COAX, DIG OPTO. If you
have selected a digital input and a valid digital source is not detected, a
blinking UNLOCKED message will appear in the upper status line and the
input will be muted.
IN MODE
defines the input configuration: DUAL CH, MONO CH1, MONO CH2, MONO
CH 1+2.
OUTPUT
selects the output mode: ANALOG, DIGITAL, ANA + DIG.
INSERT
provides for input of an external processing device to the unused
input/output pair. The INSERT parameter indicates the point in the
configuration where the external processor is inserted.
Default values are: RE-1, ANA, D-CH, ANA + DIG, OFF.
40
cursor keys have no function in this mode.
24/96 Multimode Equalizer
cursor keys, and changed with
Advertisement
Table of Contents
