Table of Contents
Advertisement
2 | Installation / Connection
Attention
• The DisplayPort connectors of the monitor consist of input and output connectors. When
connecting the monitor to a PC, connect the cable to the input connector.
• When connecting to multiple PCs, switch the input signal. For details, refer to the Installation
Manual (on the CD-ROM).
Note
• If the cables are difficult to insert, adjust the angle of the screen.
When connecting other monitors using a daisy-chain connection
The signal input to
Attention
• Visit the EIZO web site for information about monitors and graphics boards that can be used for
the daisy-chain connection:
(www.eizoglobal.com)
• Remove the
cap before connecting the signal cable.
Connect to PC
Signal cable: PP300
2. Plug the power cord into a power outlet and the power connector on the monitor.
Insert the power cord fully into the monitor.
3. Connect the USB cable to the monitor's USB upstream port and to the PC's USB
downstream port respectively.
The cable connection is required when you use RadiCS / RadiCS LE or when you
connect a USB device (USB-connected peripheral device) to the monitor.
20
is output to another monitor.
USB cable: UU300
Signal cable: PP300
Advertisement
Table of Contents
