Advertisement
1
SAFETY AND WARNINGS
WARNING!
Electrical shock hazard
Before carrying out any work on the
electrical section of the appliance, it must
be disconnected from the mains electricity
supply.
Connection to a good earth wiring system
is absolutely essential and
mandatory.
Alterations to the domestic wiring
system must only be made by a qualified
electrician.
Failure to follow this advice may result in
electrical shock or death.
WARNING!
Cut hazard
Take care - some panel edges are sharp.
Failure to use caution could result in injury
or cuts.
IMPORTANT SAFETY INSTRUCTIONS!
Particular attention shall be given to the relevant
requirements regarding ventilation.
Read these instructions carefully before installing this
product.
Please make this information available to the person
installing the appliance as it could reduce your
installation costs.
This appliance is to be installed and serviced only by an
authorised person.
Installation must comply with your local building and
local gas authority codes and electricity regulations.
Incorrect installation, for which the manufacturer
accepts no responsibility, may cause personal injury or
damage and could invalidate any warranty or liability
claims.
Appliances are factory set for LPG or Town Gas (Hong
Kong) or Town Gas (Singapore). If in doubt, refer to the
local gas network operator of gas supplier to confirm
gas type at the installation site.
Do not modify this appliance.
Do not use or store flammable materials on or near this
appliance.
Do not spray aerosols in the vicinity of this appliance
while it is in operation.
Packing elements (eg plastic bags, polystyrene foam,
staples, packing straps etc) and tools should not be left
around during and after installation, especially if they
are within easy reach of children, as these may cause
serious injuries.
You must remove the transit screws before installing the
cooktop. See step 8 of installation instructions.
Advertisement
