Oven Installation - Fisher & Paykel CMOH30SS Installation Manual

VENTILATION SYSTEM
Step
5
Wire Box
Figure 15
Step
Exhaust Damper Assembly
6
Figure 16
EN
Attach the Fan Cover Bracket to unit
z
with the 4 screws removed in step 1
above. See Figure 15. The Hood Fan
Unit is now rotated for vertical exhaust
operation.
Attach the Exhaust Damper Assembly
z
to the fan cover on the top of the
outercase cabinet by sliding it into the
slits in the same direction as the arrow.
Use 1 Tapping Screw 4 x 12 mm from the
INSTALLATION HARDWARE and tighten
into place. See Figure 16.

OVEN INSTALLATION

This oven cannot be properly installed without referring to the mounting instructions found on
both templates.
Read and follow mounting information on both
MOUNTING PLATE
Step
Separate 4 Toggle Bolts 2 , packed in the INSTALLATION HARDWARE, from the
z
1
Toggle Nuts.
Step
2
Mounting Plate
Figure 17
Step
3
Space more than
wall thickness
Wall
Figure 18
Step
4
Figure 19
and
TOP CABINET TEMPLATE WALL TEMPLATE
1
Use Wood Screws to attach Mounting
z
Plate to the stud or studs. Use Toggle
Bolts to attach Mounting Plate through
the holes at A, B, C and D; UNLESS
THOSE HOLES ARE LOCATED ON THE
STUD. Insert one Toggle Bolt into A,
B, C and D where appropriate (these
correspond to the holes of the Wall
Template) and put the Toggle Nuts onto
the Toggle Bolts. Figure 17.
Refer to instructions in Wall Template.
Position the Mounting Plate with the
z
Toggle Bolts attached at the wall location
and insert Toggle Nuts and Bolts through
the holes in the wall with the Toggle Nuts
closed. Figure 18. Use Wood Screws
attach the Mounting Plate to studs.
Note: Before insertion, be sure you leave a
space more than the thickness of the wall
between the Mounting Plate and the end
of each of the Toggle Nuts (in the closed
position). If you do not leave enough space,
the Toggle Nut will not be able to open
on the other side of the wall. Also, once a
Toggle Nut opens, it cannot be withdrawn
from the hole; therefore make sure all of the
Toggles are in the correct position before
insertion.
Align the Mounting Plate carefully and
z
hold in position while tightening Toggle
Bolts. Pull Toggle Bolt toward you and
turn clockwise to tighten. Figure 19.
.
1 to
9