Preparation Of The Oven; Ventilation System - Fisher & Paykel CMOH30SS Installation Manual

PREPARATION OF THE OVEN

1. Open the bottom of the carton, remove oven and all packing materials.
2. CHECK THE OVEN.
Check the oven for any damage, such as misaligned or bent door, damaged door seals and
sealing surfaces, broken or loose door hinges and latches and dents inside the cavity or
on the door. If there is any damage, do not operate the oven and contact your dealer or
Fisher & Paykel AUTHORIZED SERVICER.
3. Rest the microwave oven on its side as shown in Figure 6.
4. Remove the two screws which secure the mounting plate to the rear side of the oven.
Remove the mounting plate. The two screws can be discarded.
Note: If the unit you purchased does not have the mounting plate attached to the rear side of
the oven, please disregard this section and continue to Section 8.
Mounting plate
EN
Grease filter openings
Figure 6

VENTILATION SYSTEM

This Over-the-range microwave oven is designed for adaptation to three types of hood
ventilation systems. Select the type required for your installation.
A. RECIRCULATING - NON-VENTED, DUCTLESS OPERATION
The unit is shipped assembled for recirculating.
Note:
1. The Exhaust Damper Assembly (Figure 11) is not required for recirculating operation.
2. The Charcoal Filter provided with the unit must be installed behind the exhaust louver
before use. For instructions on installation of the filter, refer to the "Cleaning and Care"
section in the Use and Care Guide.
3. The Charcoal Filter should be replaced every 6 to 12 months, depending on use.
B. HORIZONTAL EXHAUST - OUTSIDE VENTILATION
Step
1
Figure 7
Step
2
Figure 8
Remove and save the 4 screws from
z
Fan Cover Bracket. Remove Fan Cover
Bracket by sliding it in the opposite
direction of the arrow on the Fan Cover
Bracket, as shown in Figure 7.
Lift Hood Fan Unit carefully and slip
z
wires out of cavity. See Figure 8.
CAUTION:
DO NOT PULL OR STRETCH BLOWER WIRING.
7