Fisher & Paykel CMOH30SS Installation Manual page 8

Step
(A) Rotate 180˚
3
(B)
Figure 9
Step
Put the wire back into the cavity.
4
Step
5
Wire Box
Figure 10
Step
6
Mounting Plate (back side)
Figure 11
8
VENTILATION SYSTEM
Rotate the Hood Fan Unit 180˚ so that
z
the fan blade openings are facing the
back of the oven. Note, you will need to
lift the wire over the hood fan unit so the
wire will clear. See Figure 9 (A). Replace
Hood Fan Unit into the oven. Be careful
not to pinch the wire and the Hood Fan
Unit. See Figure 9 (B).
Replace the fan cover bracket. Make sure
z
the fan blades are visible through the
rear openings in oven before proceeding.
Attach the fan cover bracket to the
unit with the 4 screws removed in step
1 above. See Figure 10. The hood fan
is now rotated for horizontal exhaust
operation.
Attach the Exhaust Damper Assembly
z
to the back of the mounting plate
by sliding it into the slits in the same
direction as the arrow. See Figure 11.
Using tapping screw 4 x 12 mm from the
INSTALLATION HARDWARE, tighten into
place.
C. VERTICAL VENTILATION - OUTSIDE VENTILATION
Step
1
Fan Cover Bracket
Figure 12
Step
2
Figure 13
Step
3
(A) Rotate 180˚
(C)
(B)
Figure 14
Step
Replace the Fan Cover Bracket. Make sure the fan blades are visible through the top
4
openings in the oven before proceeding.
Remove and save the 4 screws from the
z
Fan Cover Bracket. Remove Fan Cover
Bracket by sliding it in the opposite
direction of the arrow on the Fan Cover
Bracket as shown in Figure 12.
Lift the Hood Fan Unit carefully and slip
z
wires out of cavity. See Figure 13.
CAUTION:
DO NOT PULL OR STRETCH BLOWER WIRING
Rotate the Hood Fan Unit 180˚ so that
z
the fan blade openings are facing the
back of the oven. Note, you will need to
lift the wire over the hood fan unit so the
wire will clear. See Figure 14 (A). Then
rotate the Hood Fan Unit 90˚ so that the
fan blade openings are facing the top
of the oven. See Figure 14 (B). Replace
Hood Fan Unit into the oven. Be careful
not to pinch the lead wire between the
inner bracket and the Hood Fan Unit. Put
the lead wire into Wire Box. See Figure
14 (C).
EN