Table of Contents
Advertisement
9. OvEN INSTALLATION
THIS MICROWAvE OvEN CANNOT BE PROPERLy INSTALLED WITHOUT REFERRING TO THE MOUNTING
INSTRUCTIONS FOUND ON BOTH TEMPLATES.
READ AND FOLLOW MOUNTING INFORMATION ON BOTH TOP CABINET AND WALL TEMPLATES.
MOuNTiNG PlATE
1. Separate 4 Toggle Bolts 2, packed in the INSTALLATION HARD-
WARE, from the Toggle Nuts.
2. Use Wood Screws 1 to attach Mounting Plate to the stud or studs.
Use Toggle Bolts to attach Mounting Plate through the holes at
A, B, C and D; UNLESS THOSE HOLES ARE LOCATED ON THE STUD.
Insert one Toggle Bolt into A, B, C and D where appropriate (these
correspond to the holes of the Wall Template) and put the Toggle
Nuts onto the Toggle Bolts. Figure 17.
Refer to instructions in Wall Template.
3. Position the Mounting Plate with the Toggle Bolts attached at the
wall location and insert Toggle Nuts and Bolts through the holes in
the wall with the Toggle Nuts closed. Figure 18. Use Wood Screws
1 to attach the Mounting Plate to studs.
Note: Before insertion, be sure you leave a space more than the
thickness of the wall between the Mounting Plate and the end of
each of the Toggle Nuts (in the closed position). If you do not leave
enough space, the Toggle Nut will not be able to open on the other
side of the wall. Also, once a Toggle Nut opens, it cannot be with-
drawn from the hole; therefore make sure all of the Toggles are in
the correct position before insertion.
4. Align the Mounting Plate carefully and hold in position while
tightening Toggle Bolts. Pull Toggle Bolt toward you and turn
clockwise to tighten. Figure 19.
6
Mounting Plate
Figure 17
Space more than
wall thickness
Wall
Figure 18
Figure 19
Advertisement
Table of Contents
