Fisher & Paykel AWF60MD Manual page 6

Note: If a particular function fails to activate it would indicate a failure in
that area.
1. LED check
2. Prewash (Cold)
3. Main wash (Cold)
4. Softener (Cold)
5. Main wash (Hot)
6. Heater Element
7. Motor (CW)
8. Motor (CCW)
9. Drain Pump
10. Spinning
All the LED's on the display will blink.
Fills from the cold valve into the Prewash
Compartment
Fills from the cold valve into the Main wash
Compartment
Fills from the cold valve into the Softener
Compartment
Fills from the hot valve into the prewash
Compartment
Turns the heater on. For heater testing refer to
section on heater testing.
Note: If the water level is not high enough then both
the hot and cold water valve will turn on to fill to the
correct level.
Main wash motor rotates in a clockwise direction at a
speed of 52 RPM.
Main wash motor rotates in an anti-clockwise
direction at a speed of 52 RPM.
Turns the drain pump on.
Spins to the maximum speed of 1000RPM.
Note: At this point we would recommend that the test
sequence be terminated by pressing the On/Off
button. If the Start/Pause button is pressed once
more all the water valves will turn on and it will fill to
the first lever of the pressure sensor, this is used for
production testing only.
6