Usage Guidelines - InFocus LP420 User Manual

focus ring
elevator button
power
cord
connector

Usage Guidelines

Do not look directly into the projection lens when the projector is
turned on. The bright light may harm your eyes.
D
o not block the grills on the projector. Restricting the air flow can
cause it to overheat and turn off. If this happens, you must wait a minute
before attempting to turn it back on.
Handle the projector as you would any product with glass compo-
nents. Be especially careful not to drop it.
Avoid leaving the projector in direct sunlight or extreme cold for
extended periods of time. If this happens, allow it to reach room temper-
ature before use.
This projector is not intended for use in mainframe computer
rooms as defined in the Standard for the Protection of Electronic Com-
puter/Data Processing Equipment, ANSI/NFPA 75.
Transport the projector in a vendor-approved hard or soft case.
Part numbers for these cases are listed on page 35.
keypad
connector panel
speaker
F
IGURE
Side view of projector
2
3