Using The Kensington Lock - InFocus LP420 User Manual

M a i n t e
28
n a n c e &
8 Align the new lamp module in the correct direction.
9 Gently push the module in as far as it goes.
10 Tighten the screws on the outside of the module.
11 Slide the lamp connector to the left to re-attach it.
12 Insert the tabs at the top of the lamp door into the projector
and press the lamp door into place.
13 Plug in the power cord and turn the projector back on.
14 To reset the lamp hour counter in the Status bar, press and
hold the left mouse button, then press the menu button (while
still holding down the mouse button) for 5 seconds. Verify
that the counter was reset by pressing the menu button and
viewing the counter.

Using the Kensington Lock

The projector has a Kensington Security Standard connector for
use with a Kensington MicroSaver Security System (Figure 21).
Refer to the information that came with the Kensington System
for instructions on how to use it to secure the projector.
F 21
IGURE
Installing the Kensington lock
T r o u b l e s h o o t i n g