Advertisement
LP260 RS-232/CLI Values
The following table lists the RS-232 command value ranges for controlling the LP260 projector.
Note: Specified commands and values apply to the LP260 with version 7.3 software or higher. Command values for LP260s with
earlier software versions may vary. If your LP260 does not have version 7.3 software or higher, go to the
page to download and upgrade the projector software.
Note: The LP 260 requires a 9-pin DIN to a standard 15-pin serial connection available from most computer stores.
Source Independent Settings
Function/Setting
POWER ON
FORCED POWER OFF
POWER OFF
VOLUME +
VOLUME -
SOUND MUTE ON
SOUND MUTE OFF
MENU ON
MENU OFF
POINTER RIGHT
POINTER LEFT
POINTER UP
POINTER DOWN
ENTER
FREEZE ON
FREEZE OFF
FINE SYNC +
FINE SYNC -
ZOOM
FOCUS
CLI
REMARK
Command
C00
C01
POWER OFF with "POWER
OFF?"
C02
"POWER OFF?" and then
POWER OFF
C09
Same function as RC
C0A
Same function as RC
C0B
C0C
C1C
C1D
C3A
Same function as key on the
set
C3B
Same function as key on the
set
C3C
Same function as key on the
set
C3D
Same function as key on the
set
C3F
Same function as key on the
set
C43
C44
C49
Same function as RC
C4D
Same function as RC
C80
Same function as RC
C87
Same function as RC
Software/Downloads
Advertisement
