Advertisement
To assure the projector can process a command, wait 3 seconds before entering the next command.
Write Command Examples
Function
Command
Brightness
(BRT10)
Freeze
(FRZ1) or
(FRZ8888)
Power
(PWR0)
Power
(PWR1)
Error Conditions
Not all commands are supported for all projectors. If an unsupported command is issued, the command will be ignored. If a
command is received that is not understood, a '?' character will be returned indicating the command was not understood.
Limitations
The CLI cannot respond to commands coming in at a high-rate. Therefore, a delay must occur between commands to ensure that
the command gets properly executed. To assure the projector can process a command, wait 3 seconds before entering the next
command.
Response
Sets the brightness
to 10
Freezes the display
Turns power off
Turns power on
Advertisement
