ULTRASUN E6 Manual page 9

STEP 2: Assemble the topcooler (E) with the cap nuts (F) and the washers (C).
STEP 3: Place the pillar (G) between the brackets of the topcooler (E) and the bottom frame (A). The
wire tacks on the bottom side fall in the similar holes and on the top side the bolts (I) and the
washers (H) are fixed. Fasten the nuts (T) and the washers (H) on the bottom side of the pillar.
STEP 4: Assemble the brackets (J and K) at the upper and bottom side (with the bolts (L) and the
washers (C)) of the door panel (B door) and fasten the wheel (O) to the pin, which is already
preassembled to the door panel. Now hang the door part in the pin at the topcooler (E) and fasten
the upper side with the cap nut (F) and washer (M), and at the bottom with the special bolt (N).
Fasten the handle (P) with the bolts M6x45 (Q) and press the caps (S) on it.
STEP 5: Connect all plugs of the panels to the sockets in the pillar. The plugs can be connected
randomly. Always make sure that enough fresh air comes into the room.
Tighten all nuts and screws! After all actions mentioned above have been finished, the power supply
can be (re)connected. Now the sunbed is ready for use. Read the user manual of the timer for
operation. If the sunbed is not used for a longer period of time, then we recommend that you
remove the power supply.
In order to get access to the pillar (Fig.6) the screws in
the front plate can easily be removed. (see detail).
There are no parts that need maintenance situated in
the pillar, therefore open the pillar only in case of
possible technical failure.
Fig.6
9