Table of Contents
Advertisement
Changing Lamps And Starters
When the effective life of your lamps is over, or when there is an obvious decrease in the tanning
results, it is necessary to change the lamps and/or the starters.
Attention: when changing lamps, first remove the power supply, then remove
the acrylic.
Remove the acrylic sheet by loosening the plastic strips on both sides of the acrylic. Carefully lift the
acrylic and take out the endcap at the bottom, and then drop it and disassemble on the top side.
Then the acrylic can be cleaned and the lamps can be replaced. Re-assemble in reverse order. Read
the next Chapter for detailed information
Attention: Make sure that the new lamps and starters are of the same type
as the previous ones.
In order to keep your Ultrasun machine in compliance with the standard, you have to make
sure to change lamps, components and accessories with original lamps, components and
accessories only. Otherwise guarantee will be taken off as well as any responsibility and any
liability.
Exposure Schedule And Instructions E6
E6 For UV4 :
RECOMMENDED EXPOSURE SCHEDULE
CLASS
Sensitive skin
Burns easily and severely, and does
I
not tan
Light skin
Burns easily and severely, and tans
II
minimally
Normal skin
Burns moderately, and tans
III
moderately
Dark skin
Burns minimally, and tans well or
IV
above average.
Allow at least 48 hours between all exposures, tan maintenance: 1-2 times weekly
MAXIMUM EXPOSURE TIME: 15 minutes
SKIN TYPES
MAXIMUM EXPOSURE TIMES (IN
MINUTES)
week 1
week 2
week 3
Tanning not advised
4
6
8
4
7
10
4
8
12
week 4
9
12
15
17
Advertisement
Table of Contents
