Serial Interface - Citizen iDP-3421 User Manual

ESC "u" n
[Function] Sending the status for peripheral device
[Code] <1B>H <75>H n
[Range] n = 0
[Outline] This commands sends the status of the connector no. 3 pin.
[Caution] This command is valid only for the serial interface.
the connector, the bit 0 will be always "1".
host cannot receive (DSR signal has the Mark status), the printer will wait until
it will be ready to receive. In case of XON/XOFF control, only one byte will be
sent without confirming the status of the DSR signal.
time to send the status after receiving the command.
n Connector Pin
0 Drawer kick-out connector No. 3 pin
Bit Function
0 No. 3 pin's level
1 Undefined
2 Undefined
3 Undefined
4 Undefined
5 Undefined
6 Undefined
Status Sent
Value
0
"LOW"
120
iDP-3420/3421/3423 User's Manual
1
"HIGH"
If nothing is connected to
In case of DTR/DSR control, if the
Note that it may take
CITIZEN