Advertisement
'A' Fault Codes
If an A fault code is indicated, follow the steps below to try and fix the issue. If the fault persists, note down the code
before disconnecting the dishwasher from the water and
power supplies and contact Customer Care.
Display
https://producthelp.fisherpaykel.com/eu/Clean/DishDrawer%E2%84%A2/Integrated_Single/DD60SHTI9/User_Guide_DD60S...
Possible Cause
A1: Water Supply fault
A3: Drawer cannot
drain. The drainage
hose may be blocked or
kinked, or
the connection
to drainage pipe may be
blocked.
A6: The spray arm has
loosened or come off its
mounting, or water
pressure is too low. A
combination of low
water pressure and
excessive
foaming may also trigger
an A6 fault.
What To Do
1. Ensure the water supply is turned on.
2. Press ► once to stop the
beeping, and then again to clear the
fault.
3. Press
/ ► to resume the wash program.
1. Ensure the drainage hose
and connection to pipes are not
blocked.
2. Press ► once to stop the
beeping, and then again to clear the
fault.
3. Press
/ ► to resume the wash program.
1. Open the drawer and check the spray
arm.
2. If the spray arm has loosened
or come off its mounting, re-fit
it. Check that it is firmly seated
and turns freely (See 'User
maintenance instructions').
3. Press ► once to stop the
beeping, and then again to clear the
fault.
4. Press
Updated: Tue, 02 Nov 2021 07:04:16 GMT
Powered by
6
Advertisement
