Table of Contents
Advertisement
A3
fault: excess water remaining above the filter plate after the rinse cycle
Ensure hose support is correctly installed and drain hoses are routed correctly, refer to
z
'Plumbing & electrical considerations' and 'plumbing & electrical connection' for details.
Check for twisted or kinked drain hoses
z
Check for a blocked waste connection.
z
Ensure spray arms are mounted correctly and rotate freely.
z
A1
fault: no water supply
Check water is connected and turned on.
z
The DishDrawer™ Dishwasher is beeping continuously
Refer to the 'Fault codes' section of your User guide
z
No program indicator lights up when the drawer is opened
Ensure power is connected and is switched on.
z
may need to be activated. Refer to your User guide for details.
AUTO POWER-ON
z
TROUBLESHOOTING
Drawer doesn't close properly
Ensure nothing is obstructing the drawer from closing such as hoses or drawer latches.
z
Water appears around water supply and drain connections
Check hoses, connections and existing plumbing for leaks.
z
Check rubber washer and hose clamp are correctly fitted.
z
Product is tipping
Ensure the product is secured to the cabinetry.
z
Front panels are misaligned to surrounding cabinetry
Check cabinetry is square.
z
If a problem occurs that is not listed, refer to your user guide for additional troubleshooting
z
If after checking these points, you still need assistance, please refer to the Service &
Warranty book for warranty details or contact us through our website fisherpaykel.com
19
Advertisement
Table of Contents
