Fisher & Paykel SINGLE DISHDRAWER DD60STX6I1 Installation Manual page 15

1
2
3
4
FIT THE CUSTOM PANEL
Remove both side pins from the drawer.
Carefully pull the bracket out from
DishDrawer™ Dishwasher and unplug the
Knock-to-Pause module and earth wire.
Remove the Knock-to-Pause module
from the back of the bracket.
On the back of the panel, mark the
centre and align the base of the bracket
with the base of the panel.
Secure the bracket to the panel using a
minimum of 3 screws on either side.
5
6
7
8
Attach the Knock-to-Pause module to
the panel as shown.
Ensure the Knock-to-Pause module is
oriented correctly and is not in contact
with the bracket before securing.
Reconnect the Knock-to-Pause model
and earth wire to the DishDrawer™
Dishwasher.
Re-insert both side pins to secure the
panel in place.
Insert a screwdriver into the hole above
the side pin and rotate to adjust the
panel alignment. There is a maximum
travel distance of ± 2mm.
Repeat on the other side if required.
Ensure the minimum clearance gap of
2mm is maintained.
15