Feed Switch; Paper End - Citizen PPU PPU-700 User Manual

2. When using the paper holder (PHU-3***), loosen the screws (4 places
including other side) shown in the figure, adjust the holder to the specified
width, and then tighten the screws.
When the paper width is 58 mm or 67 mm, remove the E ring and move the
paper roller located at position (1) in the figure.

4.11 FEED Switch

1. The FEED switch, when pressed, feeds paper, cuts the paper, and then ejects
the paper.

4.12 Paper End

1. If no print paper is present in the printer, Busy, Fault, and PError alarms are
sent to the computer through the parallel interface or DTR output is sent to
the printer through the serial interface.
2. If data remains in the buffer, printing occurs after supplying paper.
3. Set a new paper roll in accordance with "4.5 Setting/Replacing Paper Roll".
4. After paper setting, Busy (DTR), Fault, and PError outputs are cleared.
Screw
— 35 —
(1)