Pto Shaft - Hanmey Implements AGL Series Operation, Service & Parts Manual

Lubricate PTO Shaft
Lubricate Caster Wheels
Lubricate Blade Spindle
Check Gear Box Oil Level
Clean Machine
Lubricate and Clean PTO Shaft Cover
PTO SHAFT MAINTENANCE
The PTO shaft is designed to telescope to allow for dimensional changes as the machine
goes through its operating range. A tubular guard encloses the driving components and
is designed to turn relative to the driving components. The shaft should telescope easily
and the guard turn freely on the shaft at all times. Annual disassembly, cleaning and
lubrication is recommended to insure that all components function as intended. To
maintain the shaft, follow this procedure:
1. Remove the shaft from the machine.
2. Pull shaft apart.
3. Use a screwdriver to pry the tabs out of the sleeves on each end.
4. Pull the shaft out of the plastic tubular guard.
5. Use a solvent to clean the male and female portions of the telescoping ends.
6. Apply a light coat of grease to each end.
7. Clean the grooves on each end where the tabs are located. Clean each tab also.
8. Apply a light coat of grease to each groove.
9. Insert the shaft into its respective guard and align the slots with the groove.
10. Insert the tabs through the slots and seat in the groove.
11. Check that each guard turns freely on the shaft.
12. Assemble the shaft.
13. Check that the shaft telescopes easily.
14. Replace any components that are damaged or worn.
15. Install the shaft on the machine.
Ha
MAINTENANCE
8hrs/ Daily 50hrs/Weekly
H a n m e y I m p l e m e n t s
Annually
20