Set-Up; Attachment To The Tractor - Hanmey Implements AGL Series Operation, Service & Parts Manual

SET UP

ATTACHMENT TO THE TRACTOR

Before operating the mower, carefully read this Operator's Manual, completely
understand the safety instructions, and know how to operate correctly both the tractor
and the PTO shaft, reading carefully the instruction manuals of the tractor and PTO
shaft manufacturers.
All AG flail mowers have been manufactured to be attached to any tractor provided
with hydraulic and universal 3-point hitch.
The tractor used to operate the mower must have the power, capacity, and required
equipment to safely operate the mower. Operating the mower on improperly sized and
equipped tractors may cause tractor and/ or mower damage and could be a potential
danger to the operator and passers-by.
Before attaching the equipment to the tractor, set both on a flat and smooth ground
and make sure that nobody is standing between
them.
Move slowly the tractor towards the flail mower by aligning the tractor hydraulic lift
arms to the two mower hitches' lateral brackets; stop engine and set parking brake.
Connect first the lower arms by removing the release pins of the brackets placed on the
plates, inserting the lift arms into the arms center and fastening them with the relevant
release pins, which had been removed.
Connect, then, the tractor top link to the third upper point by removing the pin located
between the plates, inserting the top link itself and locking it with the pin.
Ha
H a n m e y I m p l e m e n t s 11