Gearbox - Hanmey Implements AGL Series Operation, Service & Parts Manual

FIRST CHECK
- Check the correct tension of the driving belt
- Check that all bolts and nuts are tightened
- After the first 50 hours of work, change oil in the gearbox
EVERY 8 HOURS OF WORK
- Rotate teardrop shaped plate B and grease the shaft support (driveline side)
through the lubricating nipple A (picture 1)
- Grease the shaft support (external side) through the lubricating zerk A
(picture 2)
- Grease the shaft support (driveline) and the belt tensioner idler pin through
the lubricating zerks A and B (picture 3)
- Grease the stabilizing roller through the lubricating zerkA (picture 4)
EVERY 50 HOURS OF WORK
- Check the correct tension of the driving belt
- Check that all bolts and nuts are tightened
- Check the cutters/hammers for wear
- Check the overgear unit oil level through plug A (picture 5)
EVERY 500 HOURS OF WORK
- Check that all bolts and nuts are tightened
- Change oil in the overgear unit
EVERY 1000 HOURS OF WORK
- Replace the driving belt
-
GEAR BOX MAINTENANCE
-
-
The oil should be drained out and replaced after the first 50 hours of operation.
Then the oil should be changed every 250 hours, or at least once a year.
-
-
Drain oil from the gearbox thoroughly. Check and clean it. Fill with new gear oil up
to the dedicated oil level.
-
-
The draining procedure is as follows: remove the draining bolt under the gear box,
so that the oil drains off. After the oil is drained out, put the plug back and fill with
gear oil up to the dedicated oil
-
-
level.
Ha
MAINTENANCE
H a n m e y I m p l e m e n t s 19