Transport & Storage - Hanmey Implements AGL Series Operation, Service & Parts Manual

TRANSPORT & STORAGE
WORKING SPEED
The working speed depends on quality, diameter and height of the material to be cut;
anyway, for efficient mower performance it must be between 2 and 5 MPH. The
power takeoff speed must be 1000 RPM maximum. Operate the mower at its full
rated PTO speed to maintain blade speed for a clean cut.
ROAD TRANSPORT
Extreme caution should be used when transporting the tractor and implement on
public roadways. The tractor must be equipped with all required safety warning
features including a SMV emblem and flashing warning lights which are clearly
visible from the rear of the unit. Make sure you are in compliance with all local
regulations regarding transporting equipment on public roads and highways. Do not
exceed 20 MPH (32 kph). Reduce speed on rough roads and surfaces.
hazard flashers on the tractor when transporting unless prohibited by law.
STORAGE
If your shredder will not be used for a long period of time, respect the following
suggestions:
1. Wash the machine thoroughly and dry it.
2. Lubricate all bearings with enough grease to eliminate any cavities where
water condensation may occur and cause damage. Refer to "Maintenance
of the Machine" for location of all grease fittings. Be sure the vent on top
of the gearbox is open.
Ha
Do not exceed the rated PTO speed for
the implement. Excessive PTO speeds
can cause driveline or blade failures
resulting in serious injury or death.
H a n m e y
Always use
I m p l e m e n t s 16