Precaution - Icom IC-M302 Instruction Manual

PRECAUTION

RWARNING! NEVER
outlet. This may pose a fire hazard or result in an electric
shock.
CAUTION:
Changes or modifications to this device, not ex-
pressly approved by Icom Inc., could void your authority to
operate this device under FCC regulations.
NEVER
connect the transceiver to a power source of more
than 16 V DC or use reverse polarity. This will ruin the trans-
ceiver.
NEVER
cut the DC power cable between the DC plug and
fuse holder. If an incorrect connection is made after cutting,
the transceiver may be damaged.
NEVER
place the transceiver where normal operation of the
vessel may be hindered or where it could cause bodily injury.
KEEP
the transceiver at least 3.3 ft (1 m) away from the
ship's navigation compass.
DO NOT
use or place the transceiver in areas with temper-
atures below –4°F (–20°C) or above +140°F (+60°C) or, in
areas subject to direct sunlight, such as the dashboard.
AVOID
the use of chemical agents such as benzine or al-
cohol when cleaning, as they may damage the transceiver
surfaces.
v
connect the transceiver to an AC
BE CAREFUL!
The transceiver rear panel will become
hot when operating continuously for long periods.
Place the transceiver in a secure place to avoid inadvertent
use by children.
BE CAREFUL!
The transceiver employs waterproof con-
struction, which corresponds to JIS waterproof specification,
Grade 7 (1 m/30 min.). However, once the transceiver has
been dropped, waterproofing cannot be guaranteed due to
the fact that the case may be cracked, or the waterproof seal
damaged, etc.