Operation; Turning Power On; Channel Selection - Icom IC-F1020 Instruction Manual

Turning power ON

q Push [K
] to turn the power ON.
I
• A power-up alert tone sounds for
about 1 sec. and an opening mes-
sage may appears.
w If the transceiver is programmed
for start up passcode, input digit
codes as directed by your sys-
tem operator.
• The following keys can be used for
the password input:
• The transceiver detects the numbers in the same block as the
same number. Therefore the same effect for "1234" and "6789."
P P
KEY 0
0
NUMBER
5
e When the "PASSWORD" indication does not clear after 4-
digit input, the input code number may be incorrect. Turn
power off and start over in this case.
Opening message may
differ depending on the
pre-setting.
Input your password if
this display appears.
P P
1 2 3
1 2 3 4
6 7 8 9

OPERATION

Channel selection

There are several types are available, and channel selection
method may differ according to your system:
NON-BANK TYPE:
Push the [ ] or [ ] keys to select the desired oper-
CH UP CH DN
ating channel, in sequence; or,
push one of the [ ] to [
CH 1 CH 4
directly.
BANK-TYPE:
q Push [
], then push [
BK S CH UP
sired bank number; or
Push [ ] or [
BK UP BK DN
transceiver has these keys.
w Push [
] or [ ] to select
CH UP CH DN
the desired channel in the selected bank.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or taking the micro-
phone off from the microphone hanger.
2
] keys to select these channels
] or [ ] to select the de-
CH DN
Bank number
] if the
6