Replacing The Cable-Management Arm - IBM T-117 Installation And Maintenance Manual

Replacing the cable-management arm

If you installed a console switch in the rear of the rack cabinet, it might be easier
to replace the cable-management arm if you remove the console switch first.
Complete the following steps to replace the cable-management arm:
1. Turn off the monitor; then, disconnect power from the monitor.
2. Disconnect the keyboard, mouse, and video connectors from the server or
console switch.
3. Remove the screw that attaches the cable-management arm to the outer
slide-rail bracket.
4. Fully extend the monitor and keyboard tray; then, temporarily remove the
keyboard-and-mouse, video, and power cables from the cable-management
arm.
Chapter 3. Hardware maintenance information
19