Table of Contents
Advertisement
10. Loosely attach the back of the slide-rail brackets to the rack cabinet using four
11. Tighten the two rail-adjustment screws on each of the outer rails that you
12. Loosen the front four slide-rail bracket screws; then, insert the rail-alignment
10
IBM 17" 1 U Flat Panel Monitor Console Kit: Installation and Maintenance Guide
screws from the miscellaneous hardware kit. Make sure that the slide-rail
brackets extend outside of the rack-cabinet mounting flanges.
Note: Do not install screws in the slide-rail bracket middle holes. These holes
are for the optional console-switch mounting brackets.
loosened in step 8 on page 9.
spacer into the slide-rail middle holes. The rail-alignment spacer must wrap
around the rails to align them correctly. Tighten the front four screws; then,
remove the spacer.
Note: Do not tighten the four rear slide-rail bracket screws at this time.
Rail-alignment spacer
Advertisement
Table of Contents
