Table of Contents
Advertisement
10. Tighten the two rail-adjustment screws on each of the outer rails that you
11. Loosen the front four slide-rail bracket screws; then, insert the rail-alignment
12. If you are not replacing the inner-slide rails attached to the monitor and
13. Remove the screw and the nut that attach the inner slide rails to the monitor
14. Go to step 13 on page 11 for instructions for reinstalling the monitor and
24
IBM 17" 1 U Flat Panel Monitor Console Kit: Installation and Maintenance Guide
loosened in step 7 on page 22.
spacer into the slide-rail middle holes. The rail-alignment spacer must wrap
around the rails to align them correctly. Tighten the front four screws; then,
remove the spacer.
Note: Do not tighten the four rear slide-rail bracket screws at this time.
Rail-alignment spacer
keyboard tray, go to step 14.
and keyboard assembly; then, attach the corresponding new inner slide rails
to the tray using the same hardware.
keyboard tray in the rack cabinet; then, install any other devices that you
removed from the rack cabinet.
Advertisement
Table of Contents
