Table of Contents
Advertisement
Fitting the adjustable feet
The adjustable feet must be fitted to the base of the cooker before use.
Rest the rear of the cooker on a piece of the polystyrene packaging exposing
the base for the fitting of the feet.
IMPORTANT
Take care not to damage the cooker during this operation.
Fit the four legs by screwing them tight into the support base as shown.
Levelling the cooker
The cooker may be levelled by screwing
z
the lower ends of the feet IN or OUT.
Small adjustments may be made to the
z
cooker in the upright position, however
it may be necessary to tip the cooker
again to make larger adjustments.
FITTING THE ADJUSTABLE FEET
INSTALLING FOOT COVERS (OR90 MODELS) SIMPLIFIED
Tip range onto its back and fix
1
brackets to mounting holes.
Slot the outer panels over the
3
tensioned inner panels.
INSTALLING FOOT COVERS (OR90 MODELS) SIMPLIFIED
INSTALLING FOOT COVERS (OR90 MODELS) SIMPLIFIED
INSTALLING FOOT COVERS (OR90 MODELS) SIMPLIFIED
INSTALLING FOOT COVERS (OR90 MODELS) SIMPLIFIED
Fitting the adjustable feet covers (optional)
If using the adjustable feet covers fit these while the cooker is tipped over.
Tip range onto its back and fix
1
Tip range onto its back and fix
1
brackets to mounting holes.
Tip range onto its back and fix
brackets to mounting holes.
1
brackets to mounting holes.
1 Tip cooker onto its back and fix
Tip range onto its back and fix
1
brackets to mounting holes.
brackets to mounting holes.
Slot the outer panels over the
3
Slot the outer panels over the
3
tensioned inner panels.
3 Note: gently bend the edges of the
Slot the outer panels over the
tensioned inner panels.
3
Gently bend the sides of the inner
2
inner cover to adjust the tension
tensioned inner panels.
panels outwards to tension.
between the two parts if needed.
Slot the outer panels over the
3
tensioned inner panels.
5 Stand cooker back upright.
Stand range back upright.
5
Secure covers to brackets using
Stand range back upright.
4
5
Stand range back upright.
the provided screws
5
Stand range back upright.
5
Tip range onto its back and fix
1
brackets to mounting holes.
Gently bend the sides of the inner
2
Gently bend the sides of the inner
2
panels outwards to tension.
Gently bend the sides of the inner
panels outwards to tension.
2
panels outwards to tension.
2 Assemble the feet covers by slotting
Gently bend the sides of the inner
2
Slot the outer panels over the
3
the inner cover inside the outer cover.
panels outwards to tension.
tensioned inner panels.
Secure covers to brackets using
4
Secure covers to brackets using
4
4 Secure covers to brackets using the
the provided screws
Secure covers to brackets using
the provided screws
4
provided screws.
the provided screws
Secure covers to brackets using
4
the provided screws
Stand range back upright.
5
6 Adjust the inner panels of the foot
Adjust the inner panels of the foot
6
Adjust the inner panels of the foot
6
covers to suit height of cooker feet.
covers to suit height of range feet.
Adjust the inner panels of the foot
covers to suit height of range feet.
6
covers to suit height of range feet.
Adjust the inner panels of the foot
6
G
2
p
S
4
th
A
6
c
11
3
3
Advertisement
Table of Contents
