Table of Contents
Advertisement
Required components/tools:
T20 star screwdriver
●
●
Flat head screwdriver
●
●
Removing the top door hinge
1
Rotate the top hinge (A) outwards and remove
the top hinge pocket cover (B) using the flat
head screwdriver in the slot of the cover.
Remove the hinge by unscrewing the M5x12
2
pan head screws (2x) (C), and set aside for
later use.
Remove the hinge pocket and top alcove
3
bracket by unscrewing M5x12 pan head screws
(2x) (D) from the hinge pocket.
4
Remove the top hinge bracket and spacer (E)
by unscrewing the M5x12 countersunk screws
(2x) from the top hinge bracket.
For the non-hinge side, remove the top alcove
5
bracket by unscrewing the M5x12 pan head
screws (2x) (F). (Not applicable for RS18).
Removing the bottom door hinge
Rotate the bottom hinge (G) outwards and
6
remove bottom hinge pocket cover (H) using a
flat head screwdriver in the slot.
Remove the hinge by unscrewing the M6x16
7
countersunk screws (2x) (I).
Open the water filter hatch on the bottom
8
(fixed) grille and unscrew the #8x16 screw (J)
while holding the grille in place.
Remove the bottom grille by unscrewing the
9
#8x16 screws (K) from the bottom left and
right of the grille.
Remove bottom hinge bracket by unscrewing
!0
M6x16 countersunk screws (L).
IMPORTANT!
Do not remove plinth-to-cabinet retention
brackets!
@5
OPTIONAL — CHANGING OVER DOOR HINGES
A
B
D
F
C
E
Do not remove!
G
H
I
J
K
L
K
Do not remove!
41
Advertisement
Table of Contents
