Table of Contents
Advertisement
IMPORTANT!
Make sure that all feet engage the floor and evenly support the product. Tighten the
adjustment screw with screwdriver (do not use powered driver).
Positioning and aligning the first appliance inside the cabinetry
1
Coil the water hose flat behind the appliance. (Refer to 'Connect to water and power supply').
Before rolling the appliance, insert a barbed plug into a large hole on the cabinetry side of
2
the first appliance to protect the inside of the cabinetry from being damaged by screws on
the side of the appliance (A).
3
Roll the first appliance (preferably, Freezer) inside the cabinetry (B).
– Ensure that the water hose is not run over to prevent damage and possible water leak.
Continue rolling the appliance into the cabinetry until the anti-tip bracket overlaps
4
[minimum 7 1/8" (180mm)] the back top surface of the appliance. (Refer to 'Attach the anti-
tip bracket').
Check the clearance between the floor and the feet. Ensure the rollers of the appliance can
5
roll freely on the floor.
A
B
Note: The appliance can be rolled first into the left side or right side
of the cabinetry depending on your preference.
!6
DUAL INSTALLATION
Required components/tools:
Ruler
●
●
1x Barbed plug
●
●
Align the top cap of the first appliance flush with the front of the spacer (C).
6
Mark the step (D) of each alignment gauge based on the thickness of the door panel to be
7
installed to the door.
Align the marked steps of the gauges flush with the edges of the cabinetry side walls.
8
– Place a ruler on the steps of the alignment gauges to check if they are in line (E)
relative to the thickness of the door panel.
9
Check if the gaps between appliance and cabinetry side wall are even.
E
D
C
25
Advertisement
Table of Contents
