Advertisement
OPERATION
Start Cutting
Hold the torch vertical
at the odge Of he work
piece
Hand Torch cutting technique
When cutting make
sure that sparks are
exiting from the
bottom of the work
piece.
Piercing
Hold the torch at an
angle to the work
piece, pull the trigger
to start the arc and
slowly rotate it to an
upright position.
12
Pull the Trigger to start
the arc , the cutting arc
will initial when the
Torch tip is close
enough to the work
Piece. Start Cutting on
the edge until the Arc
has cut completely
through.
If sparks are spraying
up from the work
Piece, you are
moving the torch too
fast, or you don't
have enough amps
sel.
When sparks are
exiting from the
bottom of the work
piece, the arc has
pierced through the
material
Then. Proceed with
the cut.
Hold the torch
vertical and watch
thearc as it cuts
along the line.
When the pierce is
complete, proceed
with cutting
PLASMA CUTTER
OPERATION MANUAL
Advertisement
