Fisher & Paykel DISHDRAWER DD60SCX9 User Manual page 50

HOW TO ATTEND TO A FAULT (DD*D & DD*I MODELS)
How do I know if there is a fault?
Your dishwasher will beep continuously and the indicators on the control panel will light
●
up and flash.
Note down which indicators are lit and flashing. There are two types of fault code -
●
'A' and 'F'. See below for which type of code your dishwasher is displaying.
You may be able to fix some faults yourself - see the table on following page.
●
If you cannot clear the fault, contact Customer Care for support or to organize a visit by
●
a service technician (See 'Service and warranty' booklet for contact details).
'A' fault codes
If only the wash modifier indicators are flashing, it is an 'A' fault.
Note: Also one or more wash program indicators are lit.
'F' fault codes
If the wash modifier and the lock indicators are flashing, it is an 'F' fault.
Note: Also one or more wash program indicators are lit.
Double models only:
There may be a fault in one or both of the drawers.
●
Note down which indicators are flashing or lit in each drawer. These may be different if
●
the faults are different in each drawer.
Note:
If a fault occurs in only one drawer you are still able to use the other drawer.
●
'F' fault codes
If an F fault code is indicated, you may be able to clear the fault by re-setting the
dishwasher - see the steps below. If the fault persists, note down the code before
disconnecting the dishwasher from the water and power supplies, and contact Customer
Care.
To attempt to clear the fault code
1 Press to stop the beeping. Press
2 Wait a few seconds. Press
If the flashing indicators have disappeared then the fault has been reset and you can
continue to use your dishwasher.
46
again to turn the dishwasher off.
again to turn the dishwasher back on.