Fisher & Paykel DISHDRAWER DD60SCX9 User Manual page 47

PROBLEM
Dishes did not dry
Program is taking
much longer than
usual
Excessive motor
noise
TROUBLESHOOTING
POSSIBLE CAUSE
Incorrect loading.
Dishes were left in the
drawer for several hours
after a wash.
Rinse aid depleted.
Rinse aid setting too
low.
Normal Eco/Eco
program used.
Items that require a
longer drying time,
e.g. plastic utensils and
containers
Wrong type of
detergent used.
Auto recovery program
has been triggered to
stop the dishwasher
overflowing and to
disperse excess foam.
No water in the motor
area.
WHAT TO DO
Ensure the dishes are not nesting
together.
We recommend unloading the dishes
within a few hours after a wash
program has finished, as the small
amount of vapour left after the wash
may - with time - resettle on dishes
as condensation. Using rinse aid or
increasing its setting may also help with
drying.
Refill the rinse aid dispenser.
Increase the rinse aid setting.
Choose a different wash program.
Some models only:
Set the wash program with Extra dry.
(only available on some wash programs).
No action required. Allow the program
to finish.
Note: you may need to run your chosen
wash program again with the correct
detergent if the dishes are not clean at
the end of the recovery program.
This usually occurs on the first use or
when the dishwasher has not been used
for long periods of time. Pour 3 cups of
water into the drawer before running a
wash program.
43