Fisher & Paykel DISHDRAWER DD60SCX9 User Manual page 45

PROBLEM
Drawer will not open
(no beeping, no wash
in progress)
Power failure during
wash program
Continuous beeping
A F
with / code in
display
(DD*C & DD*A models
only)
OR
flashing wash
modifier indicators
(DD*I & DD*D models
only)
Intermittent beeping
Dishwasher will not
start
Fan noise coming
from the dishwasher
after a wash program
has finished
TROUBLESHOOTING
POSSIBLE CAUSE
Childlock feature is on.
Closed drawer auto
lock is on.
Power outage in your
home or area.
A fault has occurred.
Dishwasher is in pause
mode.
Power supply is not
connected.
The drawer is not
closed properly.
Keylock or Childlock
feature is on.
/ button not
pressed.
Dishdrawer is in
"Showroom mode".
This is normal. The
drying fan continues to
run for a set period of
time after a program
has finished to
assist with drying.
WHAT TO DO
Turn the Childlock off. See your
Quickstart guide for instructions.
Press any button and open drawer
within 30 seconds.
DD*I models only: Knock once on
the door and open drawer within 30
seconds
Wait until power resumes, program
will restart in same part of wash
program.
Refer to section 'If there is a fault'.
DD*C, DD*A and DD*D models:
Close the dishwasher and press the
button to resume the program.
DD*I & DD*D models:
Press on the control panel then
close the drawer to resume the
program.
Connect the power supply.
Ensure the drawer is firmly closed.
Turn the Keylock or Childlock off. See
your Quickstart guide for instructions.
Press the / button.
Contact Customer Care.
No action required. The fan will
automatically stop after the set time
is over, or when the drawer is opened.
In some cases, the fan may resume
when the drawer is closed again.
41